Hardi COMMANDER Classic DELTA, Инструкция

Страница: 37 / 102

4 - Sprayer setup
4.13
ATTENTION! Always use both bolts to assemble the lock. The
setting must be identical on both sides.
ATTENTION! The rear settings must correspond to the front
settings so the boom is resting on the front as well as rear
brackets.
The transport brackets and transport lock can be set in different positions. Thereby it is possible to obtain different trans-
port heights and suitable clearance above various tractor cabins. When changing the setting of the transport brackets it
is done as a combination of adjusting the transport brackets themselves and adjusting the transport locks. Always choo-
se a transport height as low as possible.
For LPY models the wire should be adjusted simultaneously with the
transport lock. A combination of adjustments described in the follo-
wing part form each transport position. This includes adjustment of
the tranport lock and the wire mounting.
To change position of the wire:
1. Loosen the nut and remove the bolt, which holds the wire (A) to
the mounting (B).
2. Place the wire (A) in correct position (please refer to chart) and
reassemble.
When the boom is unfolded: Inspect the gap between the bolt (A)
and the frame. Correct position = 1 mm gap.
If necessary, adjust the position of bolt (A).
WARNING! The max. transport height must never exceed 4.0
m (13.1 ft.). Always measure the actual total height and choo-
se settings not exceeding 4.0 m.
To change position:
1. Lift and unfold inner sections till lock is disengaged.
2. Loosen and remove the two bolts, which keep the parts (X) and
(Y) assembled.
3. Reassemble (X) and (Y) according to desired hole combination.
Transport lock
General info
Transport