To disassemble the crib and replace a side rail, end rail or a slide rod:
**We recommend this be done with 2 people**
2. Push down on both slide rods until they are clear of the upper crib eye, then lean the
entire side assembly outwards. Lift the assembly up and o
ff
of the lower crib eyes
being careful not to lose any of the small parts at the bottom of the slide rods as the spring,
washers and spacer will fall o
ff
.
3. Lastly, squeeze the Johns Hopkins handle or the Fingertip Release mechanisms on the
rail to disengage the trigger mechanisms while lifting the slide rod(s) up and out of the rail.
Disassembly
is
now
complete.
SLIDE ROD OR SIDE RAIL/END RAIL REPLACEMENT
1. At the top of one of the Slide Rods,
fi
rst lift the portion of the black plastic crib eye cover
that is over the Upper Crib Eye to expose the screw and washer underneath, then loosen
and remove the screw and washer. Repeat at the opposite side of the rail.
Upper Crib Eye
Washer and Screw
Crib Eye Cover
Slide Rod
Bumper Spring
Spacer
Nylon Washers
Slide Rod Adaptor
Lower Crib Eye
14
