Page 9
For technical questions, please call 1-888-866-5797.
Item 63842
S
AFET
y
Op
ERA
TION
N
ET
w
OR
k
SETTIN
g
S
d. Check the Camera's signal strength.
Toggle Joystick to check Camera 1.
Note:
Toggle Joystick again to check other Camera(s).
Excellent
Optimal
good
Acceptable
Low
Needs
Adjustment
Figure E
3.
Low signal adjustment:
a. Adjust the Camera and or/Receiver antenna(s).
b. Reposition the Camera and/or Receiver.
4. When the mounting location has been chosen:
a. Unplug the Power Adapter's
cord from the Camera.
b. Using the Base as a template, mark
locations of mounting holes on
mounting surface.
(See Figure F)
5. Repeat all steps with the other Camera(s).
Mounting to Solid Surface
1. Using a drill bit slightly smaller than the Screws,
drill pilot holes into the marked locations.
2. Position Mounting Bracket so that
mounting holes align with pilot holes.
3. Drive Screws through mounting holes in Base
and into pilot holes until the Mounting Bracket
is securely attached to the mounting surface.
4. Remove protective film from the Lens.
5. Loosen thumbscrews, adjust Camera as needed,
then tighten thumbscrews.
(See Figure F)
Mounting to Hollow Surface
1. Using a drill bit slightly smaller than the
Anchors, drill holes in the marked locations.
2. Tap Anchors into the holes until they are
almost flush with mounting surface.
3. Position Mounting Bracket so that Mounting
Holes align with anchor holes.
4. Drive Screws through mounting holes in Base
and into anchor holes until the Mounting Bracket
is securely attached to the mounting surface.
5. Remove protective film from the Lens.
6. Loosen thumbscrews, adjust Camera as needed,
then tighten thumbscrews.
(See Figure F)
Mounting
Holes
Base
Mounting
Bracket
Figure F
Connect power
1. Connect the Power Adapter’s cord
to the Camera’s Power cord.
2. Plug the Power Adapter into a 120VAC outlet.