Page 4
SKU 96138
for technical questions, please call 1-800-444-3353.
Hook Bar (13)
Peg Board
Support (7/8)
Peg Board (B)
Figure 1
Anchor Bolt (H)
Connect Rear Legs (5/6) to Peg Board Support (7) with two Nuts, Bolts and Wash-
ers (A) through each Leg (5/6) and Peg Board Support (7).
Connect Hook Bar (13) to each Peg Board Support (7) with Nut, Bolt and Washer
(A)-see Figure 1 and Assembly Diagram.
Secure Peg Board (C) to each Peg Support (7/8) with two Screws (B). Screws are
to be threaded through each of the lower holes in the Peg Board (8). Insert Screws
from the back with bolts and washers at the front of the Work Bench.
Secure the assembled section (Steps 1-4) to wall studs. Use the 3 holes on each
Leg and Peg Support as a guide and mark the holes onto the desired wall location.
Note that the holes for securing the Work Bench to the wall are marked by a small
plate at each hole-see Figure 1.
Set the back section of the Work Bench against the wall as desired, making certain
that the holes line up with the markings on the wall.
Pre-drill holes (drill not included), making certain that the drilling path is free of any
wires, lines and cables.
Secure the Work Bench to the wall with Anchor Bolts (H). Once the Anchor Bolts (H)
are secured to the wall, make certain that the Legs are firmly resting on the floor.
Attach Rear Table Support (2) to both rear Legs (5) using Nuts, Bolts and Washers
(A).
1.
2.
3.
4.
5.
6.
7.
8.
