![background image](http://html1.mh-extra.com/html/harbor-freight-tools/92578/92578_operation-instructions-manual_596707007.webp)
SKU92578
For technical questions, call 1-800-444-3353
Page 7
Troubleshooting
1.
If the screen will not glow while in the on position:
Check the battery. Make sure it is charged and installed properly.
2.
If the image fades or disappears completely:
a. If you are in complete darkness, the scope needs some light.
Activate the Illuminator (8).
b. It is also possible that you pointed the device at an intense light
source which might have shut down the unit to protect the intensifier
tube. Turn the power off and wait five minutes before turning it
back on.
3.
If unable to properly focus:
Try adjusting the focus on both the Eyepiece and the objective lens
on the front of the Scope (1). Also, try cleaning the lens with professional
supplies.
Maintenance
1.
Always clean the lenses with professional supplies. Never wipe dirt or
dust off the lenses. You may use dry, compressed air.
2.
Clean the housing with a dry, soft cloth.
3.
Store in a dry, well ventilated area. Never store near a heater, air
conditioner, or in direct sunlight.
4.
Remove battery when storing for more than two weeks.
5.
Service should only be performed by a qualified service technician.
Connecting the Adapter Rail for Sound Amplifier
(included in a separate box)
1.
Be sure Power Button (7) is off and that the Lens Cap (9) stays on
during this procedure.
2.
Connect the Adapter Rail (2) to the top of the Scope (1), using the
Washer (10) and Screw (11).
(See Figure C on previous page).
3.
For setup and use of the Amplifier, read and understand the instruction
sheet provided with the Super Ear™ Amplifier.