Step 2)
Place the small end of the Handle between the stays located on the Up and Down
Plate (#2). Secure in place by inserting Cotter Pin (#12) through the hole in the stay,
then through Handle (#11) and through second Stay. Place pin through Cotter
Pin (#12)-see Figure 1.
Step 3)
Slide Seat (#1) with Up and Down Plate (#2) onto the end of the Pneumatic
Pump (#5).
Step 4)
Slide Tool Tray (#8) over the bottom end of the Pneumatic Pump (#5) so that the
three (3) different Tray compartments face upward-see Assembly diagram.
Step 5)
Slide the Base (#9) up onto the bottom of the Pneumatic Pump (#5) so that the holes
in the Tool Tray (#8) rest over the holes in each leg of the Base (#9).
Step 6)
Slide the pin on the Rear Caster Wheel (#10) up through hole in the Base (#9) and
Tool Tray (#8). Slide on Washer (#6) and thread on Nut (#7). Repeat for the
remaining four (4) Rear Caster Wheels (#10)-see Figure 2.
Tool Tray (#8)-not shown
Rear Caster Wheel (#10)
Figure 2-Caster Wheel to Base
Base (#9)
Washer (#6) and Nut (#7)
Operation
To assist you with operation please refer to the Operational Figures as well as the Assembly
Diagram and Parts List located on the last pages of this manual.
Note: Do not exceed the
maximum weight capacity of 250 Lbs.
Lowering the Seat
Step 1)
While seated in the Roller Seat, press down on the Handle (#11). The Seat will lower
as you apply weight to the Seat. When the Roller Seat is at the desired height,
release the Handle (#11) and the Seat will be set in position.
Raising the Seat
Step 1)
Press down on the Handle (#11) while the Seat is empty. The Seat will raise
upward to its’ maximum height.
#47980
Page 4
Brought to You By Augusta Flint
