Page 4
SKU 42848
5.
Secure the frame assembly to its mounting location using hardware (not supplied)
through the four holes on the bottom of the Left and Right Triangle frame.
6.
Carefully place each Solar Panel (5) on the front of the frame assembly so that the
bottom of each panel fits into the slot on the bottom of the frame assembly.
7.
Lock the two eye hooks on the back-center frame into the two protruding bolts on the
Upper Link Bar (4).
8.
Attach the Wire Panel Connectors (6) to each connector on the panels.
The short cable connector must be connected to the center panel connector.
9.
Mount the Charge Controller near the Solar Panels.
This controller should be protected from the weather.
10. Connect the Solar Panels, Lamp, and 12 VDC (rechargeable) Battery (not included) as
shown above. (Also refer to the wiring diagram on page 6.)
Connections to the Charge Controller require you to press down on the red or black
tabs while inserting the stripped wire into the holes. You should not be able to pull the
wire out after releasing the tab.
The Lamp wires can be spliced to a longer cord of the same type if the Lamp is to be
used at a distance from the Charger Controller.
11. Mount the Lamp using screws (not supplied).
Eye Hooks
Wire Panel Connectors (6)
Plug connectors into panels
here
Connect wires to the Charge
Controller (8).
Refer to wiring diagram
REV 09/03
Содержание 42848
Страница 6: ...Page 6 SKU 42848 Wiring Diagram REV 09 03 ...
