13
How to Operate Your Ceiling Fan
2.
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
Figure 2
MAIN FUSE BOX
1.
IMPORTANT:
Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
Figure 1
For illustrative purposes only
-not
intended to cover all types of controls
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
Figure 4
Dip Switch
ON DIP
1 2 3 4 5
Remote
3.
To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitter, with fan
power off. Then follow the remote code setting
process. (If not used for long periods of time, remove
battery toprevent damage to transmitter). Store the
remote away from excessive heat or humidly.
(Figure 3)
4.
To set the remote code with a small screwdriver or
ball point pen (neither included), slide dip switches firmly
up or down. (Figure 4)
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from or
to other remote units, simply change the combination
code in the remote and receiver.
NOTE: Factory setting is all up. Do not use this position.
5.
Remote functions: (Figure 5)
,QGLFDWRU/('OLJKWIDQVSHHG
EXWWRQ7XUQVIDQRII
)DQ6SHHG
Turns fan on and turns speed up.
Turns fan on and turns speed down.
/LJKWEXWWRQ7XUQVOLJKWRQDQGRII
Increases light output level.
Decreases light output level.
Tap and the fan and light will turn off after
3 hours.
Tap and the fan and light will turn off after
6 hours.
Tap and the fan and light will turn off after
1 hour.
12V 23A
Battery (1 pcs)
Figure 3
Figure 5
