12
3
Gently slide remote control receiver (Q) flat-side
up into mounting bracket (C). Turn spliced/taped
wires upward and gently push wires and wire
connectors (CC) into outlet box. Let antenna from
remote control receiver (Q) hang to the side.
NOTE:
The remote control included with this fan
meets the following requirements:
a.
Not for use with solid state fans.
b.
Electrical rating: 120V / 60 Hz;
motor amps:1.25 MAX.
3.
Antenna
A
Q
C
WIRING
FINAL INSTALLATION
1.
1
Downrod
Option
Closemount
Option
B
G
D
G
D
B
Wrap electrical tape (not included) around each
individual wire connector down to the wire.
WARNING
: Make sure no bare wire or wire
strands are visible after making connections. Place
GREEN and WHITE connections on opposite side of
the outlet box from the BLACK and BLUE (if
applicable) connections.
2.
2
Wire
Connector
Temporarily lift canopy (B) to mounting bracket
(C) to determine which two canopy mounting
screws (G) in mounting bracket (C) align with
slotted holes in canopy (B) and partially loosen
these two canopy mounting screws (G). Remove
the other two canopy mounting screws (G). Now,
lift canopy (B) to mounting bracket (C) again,
aligning slotted holes in canopy (B) with loosened
canopy mounting screws (G) in mounting bracket
(C). Twist canopy (B) clockwise to lock. Re-insert
the two canopy mounting screws (G) that were
just removed and tighten all canopy mounting
screws (G) securely.
