INITIAL INSTALLATION
8. Slip downrod (A) into yoke of motor housing
(D), align holes and re-install pin (H) and clip
(J). Tighten set screws in yoke and then tighten
preassembled nuts on the set screws. Then,
slide yoke cover (E) down until it rests on top of
motor housing (D).
8
A
D
E
H
Yoke
Set Screw
and Nut
Side view
Depending on the length of downrod you use,
you may need to cut the lead wires back to
simplify the wiring. If you decide to cut back the
lead wires, it is suggested you do so in the
following manner:
Take the lead wires and make sure you have
pulled them all the way through the top of the
downrod. Start at the TOP of the hanging ball on
the downrod and measure 8 in. of lead wire, and
then cut the excess wire off with wire cutters (not
included).
IMPORTANT:
Do NOT cut safety
cable (R).
NOTE
: If you do
not
cut back the lead wires,
Steps 9 and 10 are not necessary and you
may proceed to Step 11 instead
.
9.
7. Insert downrod (A) through canopy (B) and yoke
cover (E). Thread wires and safety cable (R)
from motor housing (D) through downrod (A).
7
E
B
R
Hanging
Ball
9
A
8 in.
R
I
H
I
A
8
D
