INITIAL INSTALLATION
7
Secure mounting bracket (C) to outlet box (not
included) using screws, spring washers and flat
washers provided with the outlet box.
*
NOTE:
It is very important you use the proper
hardware when installing the mounting bracket
(C) as this will support the fan.
IMPORTANT
: If using the angle mount, make
sure open end of mounting bracket (C) is
installed facing the higher point of the ceiling, and
ensure the ceiling angle is not steeper than 19°.
5.
Remove vice (S) from safety cable (R)
preassembled to motor housing (D) by loosening
preassembled screw and nut on vice (S).
Set
Screw
and Nut
6a.
6b
6c
Nut
Screw
6a
6b.
6c.
Remove pin (H) and clip (I) from downrod (A).
Partially loosen preassembled set screws and
nuts in yoke at top of motor housing (D).
R
S
A
H
I
D
Yoke
Open End
4
C
C
ANGLE MOUNT
STANDARD
MOUNT
5
D
