6
to
9
in
8
8
INITIAL INSTRUCTIONS
Lowes.com/harborbreeze
7. Feed power wires from motor body (G) through downrod
assembly (B), then insert downrod assembly (B) into the
coupling on top housing (F).
Align the hole on downrod assembly (B) to hole on
coupling, then re-install clevis pin (U). Re-attach hairpin
clip (V) into clevis pin (U) until it snaps into place, then
tighten the two previously loosened screws on coupling.
8. Cut off excess fixture wires, leaving approximately 6 to 9
inches above the top of the downrod assembly (B). Strip
1/2 inch insulation from the end of each fixture wire.
C
CAUTION:
Ensure all screws are tight before moving
onto the next step.
B
C
D
E
6
6. Place downrod assembly (B) through canopy (C),
canopy cover (D) and coupling cover (E).
B
F
V
U
G
7
Screw
