7
3. Check existing outlet box (not included) to ensure it is
securely fastened to at least two points in a structural
ceiling member and can support the full weight of the
fan. Once verified, install mounting bracket (A) to the
outlet box using the screws and washers provided with
the outlet box.
INITIAL INSTRUCTIONS
Lowes.com/harborbreeze
4. Remove the motor body (G) from the protective plastic
bag and take the lower packing pad out of the carton.
Place the motor body (G) into the packing pad with the
bottom of each motor facing up. Remove the motor
screws (CC) and motor blocks from each motor of motor
body (G). Discard motor blocks and save the motor
screws (CC) for later use.
Hardware Used
x 6
CC
Motor Screw
5. Remove hairpin clip (V) and clevis pin (U) from the top
housing (F) preassembled to motor body (G). Retain for
later use.
3
Open End
A
A
Note:
If using the angel mount, make sure open end of
mounting bracket (A) is installed facing the higher point
of the ceiling.
Note:
Make sure to keep loose hardware separate to
avoid confusion during installation
Note:
Make sure to keep loose hardware separate to
avoid confusion during installation.
Loosen the two screws preassembled in coupling on top
housing (F), but do not remove them.
DANGER:
A loose outlet box can cause the fan to
wobble and increase the fan's potential to fall, which
could result in serious injury or death.
4
Motor Block
CC
V
U
G
F
U
Screw
5
