9
Lowes.com/harborbreeze
INITIAL INSTALLATION
7. Slide the downrod (A) into the yoke, align the holes,
then re-install the downrod pin (B) and downrod
clip (C). Secure with set screws (P) and slide the
yoke cover (I) down until it rests on top of the motor
assembly (G).
8. Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring. If you decide to cut back the lead wires, it is
suggested you do so in the following manner: Take
the lead wires and make sure you have pulled them
all the way through the top of the downrod. Measure
8 inches of lead wire, then cut the excess wire off with
wire cutters (not included).
9. If you decided to cut back the lead wire in Step 8, strip
1/2 in. of insulation from the end of the white wire.
Twist the stripped ends of each strand of wire within
the insulation with pliers (not included). Repeat the
step for black and green wires.
Note:
If you did not cut back the lead wires in Step 8,
Step 9 is not necessary and you may proceed to Step
10 instead.
C
A
I
P
B
G
7
Yoke
8
9
