WIRING
7
Fig. 1
BLACK
WHITE
GROUND/GREEN (BARE)
WHITE
WHITE
FROM FAN
120 V Power
FROM
CEILING
GREEN
FAN
GREEN
BLACK
1. [
NOTE:
For each wire connection below, and use one of the
wire connectors (K) provided, making sure to screw wire
connector (K) on in a clockwise direction.]
Connect
BLACK
wire from fan to
BLACK
wire from ceiling.
Connect
WHITE
wire from fan to
WHITE
wire from ceiling.
Connect all
GROUND
(
GREEN
) wires together from fan (on
downrod and mounting bracket) to
BARE
/
GREEN
wire from
ceiling. (Fig. 1)
Note:
Black wire is hot power for fan. White wire is common for
fan and light kit. Green or bare wire is ground.
2. Wrap electrical tape around each individual wire connector (K)
down to the wire as shown in Fig. 2.
WARNING:
Make sure no bare wire or wire strands are
visible after making connections. Place green and white
connections on opposite side of box from the black connections.
Turn spliced/taped wires upward and gently push wires and wire
connectors (K) into outlet box.
IMPORTANT
: Using a full range dimmer switch to control fan
speed will cause a loud humming noise from fan. To reduce the
risk of fire or electrical shock, do NOT use a full range dimmer
switch to control fan speed. (Fig. 3)
K
K
K
Fig. 3
Fig. 2
Dimmer
Switch
For illustrative purposes only
--
not
intended to cover all types of controls
FINAL INSTALLATION
Fig. 1
A
S
B
L
1. Locate two canopy mounting screws (L) on underside of
mounting bracket (C) and remove screw (L) closest to the open
end of the hanging bracket (C). Partially loosen the other screw
(L). Lift canopy (B) to mounting bracket (C). Place rounded part
of slotted hole in canopy (B) over loosened screw (L) in hanging
bracket (C) and push up. Twist canopy (B) to lock. Re-insert
screw (L) that was removed, and then tighten both screws (L)
securely. Slide canopy cover (S) up to canopy (B), aligning
rounded part of slotted holes in canopy cover (S) with
screwheads in bottom of canopy (B). Turn canopy cover (S) to
the right (clockwise) until it stops. (Fig. 1)
