![background image](http://html.mh-extra.com/html/harbor-breeze/e-am54ai5lkl/e-am54ai5lkl_manual_596213007.webp)
INITIAL INSTALLATION
5. Remove motor screws (P) and 5.4M/M lock
washers (Q) from underside of motor and save for
blade arm (K) attachment later on. [If there are
plastic motor blocks installed with the motor
screws (P) and 5.4M/M lock washers (Q), discard
the plastic motor blocks.] (Fig. 5)
5
L
E
P
Q
FAN MOUNTING
1.
1
B
E
S
D
Choose downrod (A) length you wish to use.* If you
choose to use the 12 in. downrod (A), remove
hanging ball from the 6 in. downrod (A) and attach to
the 12 in. downrod (A). Insert downrod (A) through
canopy (B), canopy cover (O), and yoke cover (D).
(Fig. 2). [
Note:
Canopy cover (O) must be turned with
the shiny side
toward
the motor housing (E).] Thread
wires from motor housing (E) through downrod (A).
2
Hanging
Ball
2.
Slip downrod (A) into motor housing yoke, align
holes and re-install pin (S) and clip (T). Tighten
set screws and then tighten nuts. Slide yoke cover
(D) down until it rests on top of motor housing (E).
(Fig. 3)
Set
Screw
A
3.
3
E
T
S
D
Set Screw
T
A
O
Remove pin (S) and clip (T) from motor housing
yoke at top of motor housing (E) and partially loosen
set screws. (Fig. 1)
*
Helpful Hint:
Downrod style mounting is best
suited for ceilings 8 ft. (2.44 m) high or higher. For
taller ceilings you may want to use a longer downrod
(sold separately) than the ones provided. Angle style
mounting is best suited for angled or vaulted
ceilings. Longer downrods are sometimes necessary
to ensure proper blade clearance.
7