Remove hex nut (V) and lock washer (W) from
threaded rod on light kit fitter (G). Gently feed
wires from light kit fitter (G) through center hole in
switch housing (H) and then through lock washer
(W) and hex nut (V). Secure switch housing (H) to
light kit fitter (G) by tightening the hex nut (V).
(Fig. 6)
If you wish to use the light kit
, punch center cap
out of switch housing (H) with a screwdriver.
Locate
BLUE
and
WHITE
wires in switch housing
(H) labeled FOR LIGHT and remove plastic that
holds these two wires together. (Fig. 5)
If you do NOT wish to use the light kit
, attach
switch housing (H) as described in
Step 8 on the
following page
.
Remove one screw from fitter plate (on underside
of motor) and loosen the other two screws. Align
slotted holes in switch housing plate (F) with
loosened screws in fitter plate. Twist switch housing
plate (F) to lock and re-install screw that was
previously removed. Tighten all screws securely.
(Fig. 4)
Fitter
Plate
4
E
F
4.
FINAL INSTALLATION
5.
6.
6
G
V
W
H
Connect
BLUE
wire from switch housing (H)
to
BLACK
wire from light kit fitter (G).
Connect
WHITE
wire from switch housing (H)
to
WHITE
wire from light kit fitter (G). Be sure
molex connections snap together securely.
(Fig. 7)
WHITE
BL
UE
BLA
C
K
WHITE
Molex
Connections
G
H
7
Molex
Connections
7.
Center Cap
WHITE
BLUE
5
H
12
