A
B
Remove
and save
Loosen but
do not remove
6
7
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
1. Determine mounting method.
Downrod Mount (standard or angled ceiling)
Important:
lf angle mounting, check to make sure
the ceiling angle is not steeper than 20°.
3. Install the mounting bracket (A) to the outlet box
(not included) using the two screws provided
with the outlet box. Securely tighten the two
screws.
5. Insert downrod assembly (E) through canopy
(B), canopy cover (C) and yoke cover (D).
Thread wires from the motor housing (H)
through downrod assembly (E).
Outlet box
A
3
2. Remove the mounting bracket (A) from the canopy
(B) by loosening the four screws on the top of the
canopy (B). Remove the two non-slotted screws and
save.
If using the angle mount, make sure open end of
mounting bracket (A) is installed facing the higher
part of the ceiling.
4. Remove pin and clip from downrod assembly
(E) and save.
2
1
Clip
Pin
E
4
C
B
D
E
5
6. Loosen the two set screws from the yoke. Slip
downrod assembly (E) into yoke, aligning holes
in downrod assembly (E) and yoke. Insert the
pin through yoke and downrod assembly (E),
then insert clip into pin until it snaps into place.
Tighten set screws. Slide the yoke cover (D)
down over the fan motor assembly (H).
E
D
H
Yoke
Clip
Set screw
Pin
6
Page 6
Page 7
