11
Lowes.com/harborbreeze
STANDARD OR ANGLE MOUNTING INSTRUCTIONS
7. Slide the downrod (A) into the yoke of the motor
assembly (E), align the holes, and re-install the
downrod clip (DD) and downrod pin (EE). Then
tighten the motor housing set screws (FF).
Hardware Used
DD
Downrod Clip
x 1
EE
Downrod Pin
x 1
FF
Motor Housing
Set Screw
x 2
DD
FF
A
E
EE
8. Carefully lift the downrod (A) onto the mounting
bracket (C). Rotate the downrod (A) until the slot on
the downrod (A) engages the tab on the mounting
bracket (C).
DANGER:
Failure to align the slot in the ball
with the tab may result in serious injury or death.
C
A
C
A
Tab
Slot
9. Connect the green wires from the downrod (A) and
the mounting bracket (C) to the bare/green (ground)
supply wire using a wire connector (BB).
Then, wrap electrical tape around the wire connector
(BB) down to the wire. Turn the spliced/taped wires
upward and gently push the wires and wire connector
(BB) into the outlet box.
Proceed to
Final Installation
on page 15.
Hardware Used
BB
Wire Connector
x 1
7
8
C
A
BB
9
