17
Fig. 3a
Fig. 3b
Fig. 3c
OPERATING INSTRUCTIONS
1. Remove the battery cover from the back of the remote
found in remote pack (W). Insert the battery from
remote pack (W) into the remote; ensure polarity of
battery matches the polarity indicated in the battery
compartment -- positive (+) to positive (+) and negative
(-) to negative (-). Replace the battery cover and press
the fan power button on the remote to ensure the LED
indicator illuminates and the remote turns on the fan.
Note:
If remote doesn’t turn on the fan, see
TROUBLESHOOTING (page 18).
2. To operate the fan using the remote, press and release
the following buttons:
1 - High fan speed
2 - Medium fan speed
3 - Low fan speed
4 - Fan Power - Turns the fan off.
Light Delay Off mode -
Press and hold the fan
power button (4) for five seconds, which will turn
off light after one minute. The LED indicator on the
remote will flash four times to confirm mode setting.
5 - Light Control:
Incandescent Bulbs
- Press light control to turn
lights off and on. Press and hold light control to
dim or brighten the lights.
CFL Bulbs
-Turns the lights on and off.
Note:
The
dimmer function does not work with CFL bulbs.
6 - D/CFL Switch: Switch should be set to “D” to
correspond with the included incandescent bulbs,
which will enable the dimming function. Flip to
“CFL” if you change to corresponding bulbs.
3. The reverse switch is located on the switch housing (H).
Using a ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Note:
Wait for the fan to
stop before moving the reverse switch.
In warmer weather,
push the reverse switch down to
display a sun icon, which will result in downward airflow
creating a wind chill effect (Fig. 3a).
In cooler weather,
push the reverse switch up to
display a snowflake icon, which will result in upward
airflow that can help move hot air off the ceiling area
(Fig. 3b).
Important:
The reverse switch must be set either
completely up or down in order for the fan to function
correctly. If the reverse switch is set in the middle
position, the fan will not operate (Fig. 3c).
1
2
3
4
5
6
2
1
Remote
Front
Back
Battery
Battery
Compartment
3
H
2
LED Indicator
LED Indicator
Fan Power
Reverse Switch
