12
Switch
Housing
Plate
If you wish to USE the light kit
, remove three
switch housing plate screws (R) from underside
of motor. Locate
BLUE
and
WHITE
wires in
switch housing plate labeled “FOR LIGHT” and
remove plastic from these two wires. (Fig. 5)
Connect
WHITE
wire from light kit fitter (E) to
WHITE
wire from switch housing plate. Connect
BLACK
wire from light kit fitter (E) to
BLUE
wire from switch housing plate. Make sure that
molex connections are secure. (Fig. 5)
Continue with Step 6.
If you do NOT wish to use the light kit,
please go to section entitled
“Using Fan
Without Light Kit (OPTIONAL)”
on page 14.
E
Molex
Connections
FINAL INSTALLATION
4.
R
G
N
M
Switch
Housing
Plate
4
5
5.
R
Locate motor screws (M) and lock washers (N)
that were removed in Step 5 on page 8.
Insert two motor screws (M), along with lock
washers (N), through one blade arm (G) to
attach blade arm (G) to motor. Tighten motor
screws (M) securely. (Fig. 4) Repeat with
remaining blade arms (G), making sure to
completely secure each blade arm (G) before
proceeding with the next.
Note:
For easy access to motor screws (M),
rotate switch housing plate so that the flat part
of the switch housing plate aligns with the two
motor screw (M) holes on blade arm (G).
Repeat Step 4 with remaining blade arms (G),
making sure to completely secure each blade
arm (G) before proceeding with the next.
