INITIAL INSTALLATION
7
Remove pin (L) and clip (M) from downrod (A).
Partially loosen preassembled set screws and nuts
in yoke at top of motor housing (D).
5.
5A
M
L
5B
A
Set Screw
Sideview
D
Yoke
6. Insert downrod (A) through canopy (B), canopy
cover (H) and yoke cover (E).
NOTE:
Canopy
cover (H) must be turned with the shiny side
toward
the motor housing (D).
Then, thread wires from motor housing (D)
through downrod (A).
6
B
E
A
H
4.
Open End
4
C
C
ANGLE MOUNT
STANDARD MOUNT
Secure mounting bracket (C) to outlet box (not
included) using screws, spring washers and flat
washers provided with the outlet box.
*
NOTE:
It is very important you use the proper
hardware when installing the mounting bracket (C)
as this will support the fan.
IMPORTANT:
If using the angle mount, make sure
open end of mounting bracket (C) is installed facing
the higher point of the ceiling, and ensure the
ceiling angle is not steeper than 19°.
