Harbinger MLS800, Руководство пользователя

Страница: 10 / 14

into the RCA inputs or the 1/8” TRS input, or you can switch it to use Bluetooth
for wireless connectivity via Bluetooth with your mobile audio device.
3. Channel Inputs
Channels 1 and 2 can have either XLR (microphone) or ¼” Tip Ring Sleeve plugs
(Guitar) in the inputs.
4. Aux/Bluetooth Selector Switch and Pair Button
This changes to Channel 3 input to Bluetooth from the physical inputs.To make
your mobile audio device communicate with the MLS800 you need to make sure
the device is paired. This is done by setting your device to discover Bluetooth
devices. The Device “Harbinger MLS800” should be present when you hold down
the Pair button on the MLS800 while your device is searching device.
4a. The Bluetooth Light (on front of cabinet)
The Bluetooth light will light blue when connected and will play a chime. When
your device is playing music, the Bluetooth light will blink slowly. When
connected to Bluetooth, you can press the pair button on the MLS800 to stop
playback of the connected device. Press the pair button again to resume
playback. To disconnect, press and hold the pair button. The light will turn off and
it will play a chime
5. Power / Clip LED
The Power LED is green to indicate that the MLS800’s AC power cord is
connected to an electrical outlet, and the Power Switch is turned on.
The SIG/CLIP LED will light up BLUE when the speaker is receiving
a signal. If it is distorting, the LED will turn RED and the MASTER
VOLUME should be turned down.
6. EQ Controls
The LOW EQ will p/- 12dB of boost or cut below 100Hz. Turn the LOW
EQ up to add bass or warmth to the speaker. Turn the LOW EQ down to remove
rumble and noise when the program material does not contain low frequencies,
or when using the speaker as a floor monitor. The HIGH EQ will p/-
12dB of boost or cut above 10kHz. Turn the HIGH EQ up to add clarity and
definition to vocals, acoustic instruments, or backing tracks. Turn the HIGH EQ
down to reduce hiss or feedback.
7. Power Switch
Turns the MLS800 ON or OFF
8. Fuse Carrier
Only replace the fuse when the device is disconnected from mains. Only use
fuse of the same rating and power. The correct fuse is specified on the rear panel.
9. Power cable input