HARBEN Eliminator VanPack, Руководство по эксплуатации и техническому обслуживанию

Страница: 18 / 61

18
4.3. Pre-start Checks & Bleed Procedure
1. WARNING! In cold weather check that machine is not frozen before starting (see
Antifreeze section 4.11). Serious injury can occur from ice bullets. (H&S Sections 3
and 7)
2. Only operate the machine in a well-ventilated area. (H&S Sections 3, 8, 9, and 12)
3. Park next to suitable clean water supply on a level ground.
4. Ensure vehicle handbrake is applied. (H&S Sections 3, 11, and 13)
5. To fill water tank, connect to water supply. The water will fill the tank via the inlet hose
reel when the tank is full it will flow out the overflow. ( NOTICE: To comply with water
authority bylaws never fill the tank by putting a hose directly inside )
6. Feed the end of the high-pressure hose through the hose trace on the swinging arm
in front of the hose reel. Do not fit the nozzle or gun at this point! (H&S Section 3, 6,
and 16)
7. In order to avoid an interruption to the jetting operation please ensure that the hand
held ‘radio control unit’ is fully charged, this is to ensure the radio signal is at full
strength and not compromised while the unit is being operated in ‘remote’ mode.
NOTICE: Do not drop the handheld “radio control unit” (RCU) down a manhole
as this could cause it permanent damage. Please use the lanyard provided.