HOW TO USE YOUR HAPPYHOT
BATTERY-HEATED INSOLES
1
Start by charging the insoles. Always
insert the charger plug with care.
2
Aft er approximately 4 hours, the LED
light inside the heated insoles should
change to a constant green light.
That means they are fully charged.
3
Activate and deactivate the heated
insoles by pressing the ”ON/OFF”
button for 3 seconds.
4
Set a suitable heat level by using
the remote or by pressing the ”ON/
OFF” button briefl y to change the
temperature.
5
The colour of the button shows the
current heat level.
RED
= high
BLUE
= medium
GREEN
= low
6
You can check the battery level
of the insoles by turning them off
using the remote control. If the LED
fl ashes:
RED
(0 - 33 %)
BLUE
(34 - 66 %)
GREEN
(67 % - 100 %).
7
Test the heated insoles: Put them
under a blanket for about 10
minutes. Check with your hands if
they feel warm enough.
8
If possible, remove the existing soles
from your shoes.
9
Trim the heated insoles so they fi t
your shoes if necessary. Take your
time when you trim the insoles so
they will fi t well and do not become
too short. You can use your old
soles as a template. DO NOT cut the
innermost line, as this may damage
the heating pad.
10
Insert the heated insoles into clean
and dry shoes/boots. Once you have
walked for a while, they will fi t even
better.
11
Turn the heated insoles off by
pressing the bottom button on the
remote. They are now on stand-by.
To turn them off completely, you
have to press the “ON/OFF” button
on the insoles for 3 seconds.
1x
3 sec
ON/OFF
TEMP
9
HappyHot_insoles_brugermanual.indd 9
HappyHot_insoles_brugermanual.indd 9
28.07.2021 22.38
28.07.2021 22.38
