Hanwha Vision QND-7022R, Руководство пользователя

Страница: 21 / 40

English _
21
!
INST
ALLA
TION & CONNECTION
Connecting the LAN cable
1. Remove the dome cover and the case.
2. Pull off the cable bush at the bottom as shown in the figure.
J
`
Use an appropriate cable bush for the LAN cable to be connected.
- Basic camera : Use the cable with a diameter of Ø5~6.5.
3. Pull off the extruded part of the 1-hole cable bush provided.
4. Use the Cap installer to pass through the LAN cable.
5.
Route the LAN cable through the hole created after removing the cable
bush in Step 2, and then connect it to the ethernet terminal.
6. Insert the bush of the LAN cable into the hole.
Connecting the audio/alarm cable and power cable
1. Remove the dome cover and the case.
2. Pull off the cable bush at the bottom as shown in the figure.
3. Pull off the small extruded part on the bush of the alarm/audio cable,
and route the power cable through the bush.
4. Route the alarm/audio cable through the hole left after removing
the cable bush in Step 2. Connect each to the alarm/audio
terminal and power terminal block of the PCB, respectively.
5. When mounting the camera, hang the cables on the fixed hook to
avoid cables from being damaged or pinched.
6. Insert the bush of the alarm/audio cables into the hole.
7. Adjust the lens in a desired direction by referring to the “ Adjusting
the monitoring direction for the camera
” section. (page 23)
8.
Attach the dome cover.
NETWORK LINK
ACT
12
34
56
7
GND
1 ALARM IN
2 ALARM OUT
5 AUDIO IN
CA
UT
ION
: B
e w
are
of t
he
Rat
ed V
olta
ge a
nd P
ola
rity
of t
he p
ow
er c
onn
ecti
on.
NETWORK LINK
ACT
12
34
56
7
GND
1 ALARM IN
2 ALARM OUT
5 AUDIO IN