EN
INSTALLATION
It should not be necessary to access the Installation
menu since your decoder should have been setup
when it was installed. However, it is possible to
access the following options:
change some hardware settings
configure the modem
run a channel search
check the signal level and quality
get some basic information concerning the
system and loader
download new software versions
set local time
restore all your decoder’s factory settings
DTT MODULE OSD
Local Time
The time is set automatically by reading the
information broadcast by the digital channels. It is
possible to set the Local Time Zone.
Settings
There are various system setting submenus.
1.
System Settings
Default CA System: selects the conditional
access system used
__________________________________________________________________________________________
Dolby Digital - select “Yes” if you wish to
connect to a Dolby Digital receiver to the
SPDIF digital audio output.
Auto Upgrade in Standby - When you switch
your receiver to the standby mode, the
application checks whether a new software
version is available. If a new software version
is detected, you will be informed about the
availability of the receiver’s upgrade once you
have switched your receiver into the operate
mode. However, you may switch the Auto
Upgrade option to Yes. In this case the
receiver’s software will be upgraded
automatically when the receiver is in the standby mode.
Auto Upgrade in Operate: turns on or off the OTA (Over The Air) upgrade
Time Upgrade Verification: sets the time to upgrade software. We advise you to leave the
setting during the night when the device is not in use.
Repeat Upgrade Verification: it is possible to set the frequency of software upgrade searches
LCD IDTV MHP – Rev. 1.1
7
.7
