A. Introduction
Phase One Disintegration Tester User Guide—40-108-001 Rev. A—14 November 2016
A-4
6.
Install baskets on arms by snapping into basket shaft
holder.
7.
Highlight the desired test mode—timed or free run.
8.
If a timed test, set the time limit.
9.
Start the test and monitor at appropriate points.
10. End the test and perform cleanup.
The above steps are described in greater detail in the Operation
section of this user guide.
Recommendations for Using This Manual
Hanson Research recommends the following steps for making
best use of this user guide:
1.
Review the Introduction section for an overview of the
instrument.
2.
Carefully review and follow all safety instructions.
3.
Unpack, inspect, and install the tester according to
instructions in the Installation section.
4.
Conduct an initial test of the system using the
procedures outlined in the Operation section.
5.
Review the cleaning, maintenance, and troubleshooting
sections to become familiar with keeping the tester in
good working condition.
6.
Immediately contact Hanson Technical Support with any
questions on how to properly operate and maintain the
Phase One Disintegration Tester.
