D. Operation
Phase One Disintegration Tester User Guide—40-108-001 Rev. A—14 November 2016
D-7
Setting the Temperature and Timer
To set the target temperature:
1. Press menu button to access set point menu.
2. Set desired temperature using increase/decrease buttons.
3. Press the run button to start the timer and the temperature
control.
When the timer is running, the remaining time and the set point
temperature will appear alternately on the display.
When the time period has elapsed, the circulator will make a
beeping sound three times, then go silent for 15-20 seconds
and then repeat the beeping sound. The circulator will continue
circulating the bath fluid at the set point until the Stop Button is
pressed, which will stop the beeping and also reset the timer.
To access the timer, press the menu button twice and then enter
the desired time period using the (+/-) buttons. The timer range
is 00:05 to 99:00 (hh:mm). The factory default value is 24:00
For details on heater/circulator operation, see LX Immersion
Circulator Operator’s Manual 110-874 PSC/EN.
