14
-
30
Hanskamp AgroTech B.V. (the Netherlands)
www.hanskamp.nl/en
MultiDos
EN
Dosing system –
Dosiersystem –
Systeme de dosage
-
Doseersysteem
4.
Unscrew the casing of the pump housing.
5.
Make a hole in the middle grommet with a small flat screwdriver. Press
the cable of the motor through that hole. This cable gets attached to the
relevant control unit. For a correct installation, consult the installation
instruction of the relevant control unit. Do this when the mounting of the
MultiDos is completed.
6.
Mount the feed
-
through coupling (art. no. 003
-
574
-
000) in the 2 outer-
most holes of the wall attachment and secure these with a union nut
(art.no. 001
-
886
-
000) as indicated in diagram 30.
7.
Steadily screw the pump housing with the accompanying screws (art. no.
003
-
510
-
000) hand
-
tight on the wall attachment. (Diag. 29)
8.
Loosen the rotor of the pump by turning anti
-
clockwise and remove it
Attention! By loosening of the rotor by hand, minor injuries can oc-
cur.
Attention! Hanskamp only guarantees a correct operation when the suction
hose is 2 meters or shorter. Use the 5 meter hose as a delivery hose.
Attention! HanskampQualityTube is not suitable for acids. A suitable hose kit for
acids can be ordered from Hanskamp upon request.
Attention! Cut the hose off straight. When the hose is cut off skewed, it
may impair the operation.
Attention! Make sure that the end of the suction hose is placed at the bottom of
the container, otherwise the pump cannot pump all the liquid.
29
32
30
31
5
