Assembly
Page GB-12
Place the drill holes
WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
■
Before drilling the holes, ensure that
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
■
The distance between the cooking
surfaces and the lower edge of the
hood must be at least 65 cm for gas
stoves.
■
For gas stovetops, you must read the
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line
on the wall. Ideally, use a level or a plumb
bob from the ceiling of the room to the
middle of the stovetop.
2. Draw the five drill holes on the wall, fol-
lowing the diagram on page GB-10. Pay at-
tention to the hole distance and horizontal
orientation of the wall brackets.
3. Drill holes at the marked points, using a
diameter that can accommodate the dow-
els.
4. Place the dowels into the holes.
Attaching the exhaust hood
(5)
(5)
Pins
1. Place the two halves of the check valve
(5) into the opening on the top of the ex-
haust hood (1). Make sure that the pins
on the valve are facing outwards.
(8)
(12)
2. Screw the wall bracket (8) for the exhaust
hood into the dowels using three round-
head screws (12).
(8)
3. Hook the exhaust hood onto the wall
bracket (8).
196376_GB_20180518.indd GB-12
196376_GB_20180518.indd GB-12
18.05.2018 09:02:22
18.05.2018 09:02:22
