Operation
Page EN-11
Before getting started
– Read Chapter ‘Safety’ from
page EN-5 and all the safety notices.
– Set up and connect the appliance as
described in chapter ‘Start-up’ from
page EN-17.
Switching the appliance on
and off
NOTICE
Risk of damage!
If the refrigeration unit has been trans-
ported horizontally, lubricant from the
compressor may get into the cooling
circuit.
■
Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting.
Switching on
• Insert the mains plug into an easily acces-
sible socket (220–240 V~ / 50 Hz).
The appliance is then switched on. The
compressor starts to work, the refrigerant
flows through the pipes and a quiet hum-
ming sound can be heard.
Switching off
1. Pull the mains plug out of the socket.
The compressor is switched off. The appli-
ance no longer refrigerates.
2. Empty the appliance and clean it (see
‘Care and maintenance’ on page EN-15).
3. Leave the glass door (2) slightly ajar to
prevent mould from forming.
After switching off , wait for approx.
5 minutes before switching the appli-
ance back on. The compressor requires this
amount of time to re-start.
Operation
Setting the temperature
WARNING
Health hazard!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
■
Always adhere to the prescribed am-
bient temperature (see correspond-
ing data sheet at the end of this user
manual).
1
2
4
5
3
(8)
The temperature adjuster (8) is situated on
the lower section of the rear left-hand side of
the appliance.
The appliance’s chilling capacitiy can be ad-
justed in increments of ‘1’ to ‘5’.
The lowest temperature can be set by adjust-
ing to ‘5’, the highest temperature by adjusting
to ‘1’.
• To increase the refrigerator’s chilling
capacity, turn the temperature adjuster
clockwise
towards ‘5’.
The setting ‘5’ is reached by turning the dial
clockwise as far as it will go.
