Start-up
Page EN-38
Adjusting the doors
It may be that the doors are not on the same
level, even if the appliance itself is completely
level.
In this case, you can adjust the position of
the doors by lowering or lifting the door to the
fridge.
NOTICE
The doors can be adjusted by a maxi-
mum of 5mm.
1. Open the door to the fridge wide.
(42)
(44)
(43)
2. Turn the locknut (43) two full rotations
clockwise to loosen it. Use the spanner
supplied to do this.
3. Turn the adjusting nut (44) either clock-
wise to lower the door or anticlockwise to
lift the door.
4. Tighten the locknut (43) again by turning it
anticlockwise.
Cleaning before use
To remove production residues and odours in
all new appliances, thoroughly clean the ap-
pliance’s interior as well as the ice dispenser,
ice cube container, water dispenser and wa-
ter tank before starting up an appliance (see
chapter “Care and maintenance” from page
EN-30).
Setting up the appliance
1. Place the appliance upright on as flat and
as firm a base as possible.
2. To ensure adequate air circulation,
– maintain a minimum distance of 3 cm to
the rear wall.
– maintain a distance of 10cm on the
sides.
– free an area of at least 30cm above the
appliance.
– do not place any objects on the appli-
ance.
– do not place the appliance on carpeted
flooring.
Aligning the appliance
1. Check the position with a spirit level.
(42)
2. Level out any unevenness on the ground
using the two front screw feet (42).
– Close the doors to do this.
– Tilt the appliance backwards slightly and
screw/unscrew the screw feet.
– Stand the appliance back up again and
check the alignment with a spirit level.
– Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the
doors.
