Page EN-18
The oven
Replacing the oven door on its
hinges
1. Hold the oven door at an angle using both
hands.
2. Hook the hinges into the holes in the side
panels.
3. Open the oven door completely.
4. Fold the clips
X
on both sides all the way
back.
5. Close the door carefully. The door must
sit flush when closed. If the door does not
sit flush when closed or if there is a crack-
ing sound when closing it, the door is not
hung properly.
6. Correct the position of the hinges and
clips, if necessary, until the door opens
and closes smoothly again.
Cleaning the glass panes
The oven door contains three glass panels
that should occasionally be cleaned on both
sides. To do this you’ll need a PH1 flat-head
screwdriver.
1. Take the oven door off its hinges see „Re-
moving the oven door from its hinges“ on
page EN-17).
2. Remove both screws that secure the top
metal grid.
3. Carefully removed the metal grid.
(19)
4. Remove the upper pane from the
mounts below the hinges and carefully
set it down.
5. Remove the middle pane and carefully
set it down.
6. Please ensure not to lose the small
spacers (19).
7. Clean all panes with warm, fresh water.
8. Dry the panes thoroughly.
9. Reposition the middle pane in the
mounts at the hinges.
10. Replace the spacers (19) at the sides of
the middle pane.
11. Reposition the upper pane in the mounts
at the hinges. Make sure that the smooth
side is facing outwards.
12. Put the grid plate back on top of the door
– it only fits in one direction. First insert
it on the left-hand side and then press
down on the right-hand-side until it clicks
into place.
