2
English
Technical Information
Water pressure
Recommended
15 - 75 PSI (0.1 - 0.5 MPa)
Maximum
145 PSI (1 MPa)
Hot water temp.
Recommended
120°-140° F*(48° -60° C*)
Maximum
158°F*(70° C*)
Max. flow rate
1.2 GPM (4.5 L/min)
Hole size in mounting surface
spout
1⁵⁄₁₆" (34 mm)
valves
1³⁄₁₆" (30 mm)
Max. depth of mounting surface
1³⁄₁₆" (30 mm)
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly before
beginning installation. Make sure that you have all
tools and supplies needed to complete the installation.
• The drain is suitable for most, but not all, lavatory sinks
sold in the United States and Canada.
• This drain is intended for use in a sink with an overflow.
If your sink does not have an overflow, or if this drain
is too small for the hole in your sink,
please refer to
the instructions included with the sink
. Some
sinks include special drain installation instructions and/
or parts. Others require the use of a specialty drain.
Hansgrohe is not respnsible for the cost of a specialty
drain.
The hot and cold supply hoses included
with this faucet are for use with ⅜ stops. If
your stops are a different size, install new
stops. Adapters are not available from
Hansgrohe.
• Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a safe
place. The receipt is required should it be necessary to
request warranty parts.
