Hanover KAMADO, Руководство пользователя, Страница: 7 / 16

4. Unpack the Top Dome Handle.
8. For Built-in Application-Place the Stainless Steel Efficiency Plate in the
bottom of the firebox with the small leg spacers facing down.
9. Place the ceramic Firebox into the grill so that the Bottom Air Control Port
aligns with the bottom Air Control Door on the grill. Place the Fire Ring on
top of the Firebox with the three notches facing upward and with one of the
notches all the way to the back. Fig. 7
Placing Grill in Cart
6. With assistance, grip the stainless steel hinge and grip inside the bottom air control and lift the grill into
the Cart. The front of the grill should be located between the two legs with locking caster wheels.
Placing Grill in Built-in Enclosure
7. If you are placing the grill into the hole of an enclosure one person should grip the stainless steel hinge
at the rear of the grill. The second person should open the lid and grip the Bottom Air Control from the
inside of the grill. Keep the other hand on the Main Handle. Put the grill into position on the feet or slab.
5. Check the rest of the pre-installed acorn nuts to ensure that they are all tight
(use the 10mm wrench). Fig. 6 If the acorn nuts spin without tightening,
just use a rapid jerking action as you tighten and this usually cause them
to tighten sufficiently. The pre-installed Band Tension Bolts should also be
checked for tightness.
3. Remove the cardboard pad from the bottom inside of the grill and discard.
2. Remove the packing materials from around the perimeter of the Firebox
and lift it out of the grill. Set it aside. It is easiest to lift it by the holes or the
clean-out port at the bottom.
Fig. 4
FINAL GRILL ASSEMBLY
Page 6
Fig. 4
Fig. 3
Fig. 7
Fig. 5
Fig. 6
Acorn Nuts
Note:
There are 2 acorn nuts packaged with the handle. Use the acorn nuts to fasten the
handle to the two screws protruding from the stainless steel band on the front of
the grill.
Fig. 5
Note:
The Band Tension Bolt may be tightened very securely without fear of damaging the ceramics (usually 2 or 3
revolutions). This ensures that the hinge will be stable and secure and that you may use the hinge or shelf brackets to
lift the grill without incident. Use the 5mm or 3/16 hex key (Allen wrench) to hold the bolt in position. Use the 10mm
wrench to turn the nuts. Do not turn the bolt as it may ruin the threads.
Unpack the Grill
1. Remove the packing materials from around the perimeter of the ceramic
Fire Ring and lift out of the grill. Set it aside. It will be necessary to hold
the Fire Ring from the inside to avoid pinching your fingers. Fig. 3
Proceed to step 9.