Step 4:
After making any necessary adjustments to the
alignment of the table legs and the leg connector
bracket, use hex bolt driver to tighten all bolts.
Note:
Each bolt must be tightened a few revolutions
at a time. In order to apply equal pressure to all bolt
joints, we recommend working in a cross corner
(X fashion). Repeat until all bolts are tight.
Do not
over tighten
. Over tightening may strip bolts or
damage the welds or frame. Cover all bolts with
covers.
Step 5:
With the help of another person, turn the table in the
upright position. Note the clear bumpers spaced
evenly throughout the inside of the rim. Carefully
place glass inside the rim, resting on the clear
bumpers. Your table is now ready for use. If you
have any questions, please call our Customer Service
Center at 1-800-416-3511.
IMPORTANT NOTE: Damage to welds or frames
resulting from over tightened bolts or improper
assembly is not covered under our warranty. Please
read all instructions carefully before assembly. If you
have any questions regarding your assembly, call our
Customer Service Center at 1-800-416-3511.
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE WARRANTY CLAIMS PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND COPY OF RECEIPT
PARTS LIST
ORDER PART #
DESCRIPTION
BOLT COVER
Ø6.5 X 1.0 MM
WASHER
HEX BOLT DRIVER
1/4" X 25 MM BOLT
1/4" X 35 MM BOLT
TABLE LEG
LEG CONNECTOR
BRACKET
TABLE RIM
GLASS TOP
QTY
1
12
1
1
1
12
4
8
4
A
B
C
D
E
F
G
H
I
BUMPER
FACTORY ASSEMBLY
G0002
HW0105
HW0004
HW0037
HW0142
HW0006
FOOT CAP
FC0069
FOOT CAP
FACTORY ASSEMBLY
Step 1:
Carefully remove glass and set aside until Step 5.
Lay glass flat--do not stand glass on edge. Remove
all protective materials and set parts on a flat, non-
abrasive surface. Identify parts packed in carton
against the parts list. If you are missing any parts or
are unsure how to proceed with assembly, call our
Customer Service Center at 1-800-416-3511.
Do
not attempt assembly if any parts are missing or
damaged.
Step 2:
Place the table rim (without glass) upside down on a
flat, non-abrasive surface. Attach the table leg to the
rim by using a 1/4"x25 mm bolt and a washer as shown
in
Figure1
. Guide the bolt through the hole in the table
leg, into the pre-drilled hole in the table rim.
Do not
tighten completely
. Some adjustments may be necessary
to ensure proper alignment of the table legs. Repeat for
the other
three table legs.
Step 3:
Attach the leg connector bracket to the legs by using the
1/4"x35 mm bolts as shown in
Figure 2.
Add a washer
to each bolt. Guide these bolts through the holes in the
leg connector bracket, into the fixed nuts already in
place
in the legs.
Do not over tighten
.
Figure1
Figure2
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
I
H
G
F
H
I
BKS04310
ST1601
ST1602
ST1603
