Step 4:
by using four 1/4"x4 mm bolts and washers as
shown in
Fig.5
. Guide the bolts through holes in base, into the pre-drilled holes in the seat.
Hand tighten only.
Step 5:
Using the hex wrench and hex bolt driver
provided, tighten all nuts and bolts.
Do not over
tighten bolts. If nuts and bolts are too tight or too loose, the glider will not function
properly.
Test the operation of glider. Gliding motion
should be smooth. Adjust tension
on the glider
brackets, nuts and bolts as needed. Cover nuts
and bolts with covers provided.
Step 6:
With the help of another person, turn the chair in the upright position. Your chair is now
ready for use. If you have any questions, please call our Customer Service Center
at 1-800-416-3511.
Attach the complete base to the complete seat
5
IMPORTANT NOTE: Damage to welds or frames resulting from over tightened bolts or
improper assembly is not covered under our warranty. Please read all instructions carefully
before assembly. If you have any questions regarding your assembly, call our Customer Service
Center at 1-800-416-3511.
BGS12023
G0080
PARTS LIST
NUT COVER
HW0027
HW0695
BOLT COVER
-
2
HW0105
HEX BOLT DRIVER
HW0006
HEX WRENCH
HW0009
1/4" NUT
HW0014
SEAT FRAME
4
4
4
1
1
1
1
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
4
4
4
HW0004
HW0138
1/4" X 45 MM BOLT
HW0040
DESCRIPTION
ORDER PART # QTY
GLIDER BRACKET
FACTORY ASSEMBLY
ST4
.
8 X 25 BOLT
FACTORY ASSEMBLY
FOOT CAP
FACTORY ASSEMBLY
FC0013
Ø6.5 X 1.0 MM WASHER
Ø6.5 X 6 MM WASHER
6
5/16" X 25 MM BOLT
HW0186
8
5/16" X 40 MM BOLT
HW0275
HW0005
Ø8.5 X 1.5 MM WASHER
BOLT COVER
-
1
HW0105
14
* NOTE: PARTS SHOWN BELOW ARE NOT TO SCALE
BACK FRAME
1
LEFT ARM
1
RIGHT ARM
1
GLIDER BASE W/
GLIDER BRACKET
1
SUPPORT FRAME
14
J
H
I
SG0154
SG0155
SG0156
SG0157
SG0158
SG0159
Fig.5
