V. Exclusion from Z-Wave network
The sensor can be excluded from the Z-Wave network by following steps:
（
1
）
Power on the device
（
2
）
Set z-Wave gateway/hub to exclusion mode (see Z-Wave gateway/hub Operation
Manual)
（
3
）
Triple click
the device's Z-Wave button
（
4
）
The LED indicator of the sensor will keep flashing quickly. If the exclusion is succeeded,
the LED light will be flashing slowly (enter the SmartStart function). Otherwise, after a
timeout of 30 seconds, it will be off and please repeat the operation of step (2) to include to
the network.
Ⅵ
. RESET THE DEVICE
Reset procedure clears the Multisensor’s memory, including Z-Wave network controller
information. To reset the Multisensor:
（
1
）
Power on the device,
（
2
）
press and hold the Z button for more than 20 seconds
（
3
）
If holding time more than 20 seconds, the LED indicator will keep on for 2 seconds,
which means resetting is complete.
（
4
）
The reset feature works only when the device has been included into a Z-Wave
network.
Note:
Use this procedure only in the event that the network primary controller
is missing or otherwise inoperable.
Ⅶ
. ASSOCIATIONS
Association allows Multisensor to control other Z-Wave device such us Smart Switch,
dimmer,etc.
Multisensor supports two association groups.
Multisensor can max associate 5 nodes in each group.
Group 1 reports the conditions of the Multisensor, battery level, temperature, humidity,
luminance and motion detection.
Group 2 is assigned to the Multisensor sends BASIC SET command.
!
