Scale gun set
Scale gun set
Assemble the canopy to the cockpit with screws.
Assemble the cockpit to the fuselage.
Assemble the scale gun set to the wing and the fiber
scoop to the fuselage.
1.5mm
TP Screw (2.3x8mm)
8
TP Screw (2.3x8mm)
Blind Nut
2
Screw (3x20mm)
200mm
253mm
Epoxy the fiber deconations to aprropriate position
on the bottom of the wing.
The centre of the Gravity.
The skech map of the Spitfire plane install
completion.
130 mm
130 mm
scoop
63
64
61
12
65
60
62
2
Servo tray(68.5x56.5x2mm)
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Make sure hinges are
mounted in the same line.
6
Pivot & round hinge(5x68mm)
6
4
Clevis
（
2mm)
4
4
Screw (2x10mm)
Locknut (2mm )
2
Push rod
（
2mm)
4
Washer(2x5mm)
Horn
2
1mm
Aileron
Trailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Pivot & round hinge(5x68mm)
Pivot & round hinge(5x68mm)
Horn(2mm)
Rod (2x300mm)
Ball joint
Washer(2x5mm)
Screw (2x10mm)
Nut (2mm )
4
Wooden Block(20x20x8mm)
Ball joint
Lock Nut (2mm ) Washer(2x5mm)
Screw (2x10mm)
Install the servo as the illustration below.
Install the nylon control horn and connect the linkage.
Apply instant AB glue to aileron and pin hinge.
Assemble the aileron to main wing with instant type AB glue. Be careful
to ensure the moving parts of the hinges are able to move freely.
Keep some space about 1mm width between the
trailing edge and the aileron.
1
2
3
4
5
1
Accessory list for the coming installation steps.
