29
Hangar 9 P-51D Mustang Sport 40 Assembly Manual
Step 21
Attach the clevis to the center hole on the aileron control
horn. With the servo centered, thread the clevis on the
linkage wire. Adjust the clevis so the control surface is
centered as shown in the second photo. Once centered, slide
the clevis retainer over the forks of the clevis to prevent it
from opening accidentally.
Step 22
Repeat Steps 11 through 21 to complete the servo installation.
Installing the Fixed Flaps
The P-51D Mustang is a special trainer plane in that it will
allow you to go from learning the basics of flight all the way
up to performing aerobatics without upgrading or purchasing
a new plane. As you learn to fly and become ready for a little
more challenge, the P-51D Mustang will grow with you.
If you plan on installing the operational flaps you can skip
this section of the manual.
Required Parts
Wing panel (right and left)
Flap stay (black and white)
Clevis retainer (2)
Clevis (2)
3-inch (76mm) flap pushrod (2)
#2 x 3/8-inch self-tapping screw (8)
Required Tools and Adhesives
30-minute epoxy
Phillips screwdriver: #1
Step 1
Locate the items necessary to install the aileron servos.
Step 2
Use 30-minute epoxy to glue the flap stay in the wing. Note
the position of the holes in relationship to the wing.
Step 3
Use four #2 x 3/8-inch self-tapping screws to secure the flap
servo cover to the wing.
