55
Hangar 9 Jackal 50 ARF
7. Slide a #4 lock washer, then a #4 washer on a
4-40 x 1-inch socket head machine screw.
8. Insert the screw into the hole in the bottom of the
fuselage. The screw will thread into the blind nut installed
in the wing. Use a 3/32-inch hex wrench or ball driver to
tighten the screw.
9. Use a #1 Phillips screwdriver to thread the 3mm x
8mm sheet metal screw into the fiberglass inlet. Allow a gap
of 1/8-inch (3mm) between the edge of the fairing and head
of the screw.
10. The head of the screw will fit into the keyed
opening in the fuselage. Slide the fairing rearward and
against the leading edge of the wing. If the screw is too far
in, it may be difficult to install the fairing. Loosen the screw
slightly until the fairing can be installed.
11. Use a 1.7mm x 6mm sheet metal screw to secure
the fairing in position. Use a #1 Phillips screwdriver to
tighten the screw.
12. Repeat Steps 5 through 11 to attach the remaining
wing panel to the fuselage.
13. Connect the linkages to the retract servo if you have
installed mechanical retracts.
