12
.
.
Step 2
Tie.the.string.to.the.servo.extension.and.insert.the.servo.
into.the.wing..Use.the.string.to.pull.the.servo.lead.through.
the.wing..Position.the.servo.so.the.output.shaft.is.toward.
the.trailing.edge.of.the.wing..Use.a.1/16".(1.5mm).drill.
bit.to.drill.the.locations.for.the.servo.screws..Mount.the.
servos.using.the.hardware.provided.with.the.servos.
.
.
Step 3
Mix.a.small.amount.of.30-minute.epoxy.and.lightly.coat.
the.inside.of.the.hole.in.the.aileron.and.the.8-32.x.2
.
1
/
4
".
control.horn.screw..Thread.the.screw.into.the.hole.from.
the.top.of.the.surface..Wipe.away.any.excess.epoxy.on.the.
wing.and.screw.with.rubbing.alcohol.and.a.paper.towel..
Screw.the.8-32.flanged.nut.in.place.as.shown..Allow.the.
epoxy.to.fully.cure.
.
.
Step 4
Screw.the.molded.swivel.link.onto.the.8-32.screw.until.
the.distance.from.the.aileron.surface.to.the.top.of.the.link.
is.1
.
1
/
8
".(28.6mm).
Section 2 – Aileron Servo Installation