Step 4
Install the Front Ankle Bar
• Insert the Front Ankle Bar (EP-1045B) into the Front Ankle Bar Housing (Figure 13). Pull up on the T-Pin Lock to insert
the Front Ankle Bar all the way and release in the shortest setting (the hole closest to the Front Ankle Bar).
• From the reverse side, pull on the zip-tie to stretch the Retainer Spring and Cable Loop so that they align with the hole
at the back of the Front Ankle Bar Housing (Figure 14).
• Insert the Bolt (H1-1212) through the hole, both loops and the hole on the other side of the housing.
• Tighten the Nut using the 10/13mm Wrench (F5-1088) provided.
• Cut the long portion of the zip-tie with scissors (Figure 14A) and cover the open end with the End Cap (F5-1048)
(Figure 17B).
Install the Foam Rollers
• Slide the Foam Rollers (F5-1051) onto the Front Ankle Bar (Figure 15).
TIP: To assist with assembly, repeatedly rotate the Foam Roller while pushing it onto the Front Ankle Bar.
WARNING
!
Do not apply lubricants to any part of the inversion table.
Failure to assemble the T-Pin Ankle Lock System properly could result in serious injury or death!
Figure 13
Figure 14
Figure 14A
Figure 15
Retainer Spring &
Cable Loop
1
1
1
Front Ankle Bar Housing
1
Figure 17B
(continued)