Step 3
Attach the Table Bed (F2-1130) to the A-Frame (FF-1100)
• Pick up the Table Bed, holding each side near the Roller Hinges, and stand in front of the A-Frame where the Crossbar
is located (refer to Figure 1 to determine A-Frame Front).
• Lower each Roller Hinge Pivot Pin into the A-Frame hinge plates, one side at a time (Figure 6 and 6A).
NOTE: You may need to push outward on the A-Frame in order for the 2nd Pivot Pin to lock in place.
• Make sure that each Pivot Pin is seated at the base of the slot of the Hinge Plate (Figure 7).
• Ensure that the Self-Locking Hooks have closed over both Pivot Pins, and that the Table Bed rotates smoothly.
WARNING
!
Failure of the Self-Locking Hooks to close over both Roller Hinge Pivot Pins is an indication
of improper assembly and if not corrected could result in serious injury or death!
2
Self-Locking Hook
Roller Hinge Pivot Pin
1
1
2
Self-Locking Hook
1
Roller Hinge
2
1
2
Figure 7
Figure 6A
Figure 6