Assembly Instructions #LG9501 Pg. 4
For information about the Teeter Hang Ups
®
5-year warranty, or if you have any
problems assembling the equipment or questions about its use, please contact Customer
Service at the appropriate location below:
USA & Canada:
STL International, Inc.
9902 162
nd
St. Ct. E., Puyallup, WA 98375
Toll Free (Phone) 800-847-0143 (Fax) 800-847-0188
Local (Phone) 253-840-5252 (Fax) 253-840-5757
(email) [email protected] (web) www.STLIntl.com
International:
Inversion International, Ltd.
PO Box: AP 59245, New Providence Island, Bahamas
(Phone) +1-242-362-1001 (Fax) +1-242-362-1002
(email) [email protected] (web) www.InversionInternational.com
U.S. and foreign patents apply. Other foreign patents pending.
Teeter Hang Ups
®
is a registered trademark of STL International, Inc.
and Inversion International, Ltd.
Specifications subject to change without notice.
© COPYRIGHT 2005, STL International, Inc. and Inversion
International, Ltd. International Law Prohibits Any Copying, 11/05-2
* any modification to this device
will void the UL Classification
Classified as Medical
Equipment, part I in accordance
with UL 2601-1 and CAN/CSA
C22.2; General Requirements
for Safety in accordance with
Underwriters Laboratories, Inc.
Figure 11
STORING THE INVERSION TABLE
IMPORTANT NOTE: The GL9500
TM
will not fold for storage while in Setting “C”
of the roller hinge. You must have the roller hinge set in either the “A” or “B”
setting to do so.
•
Loosen the de-rattler knob.
•
Pull the height selector locking pin and slide the main shaft in all the way
to the ankle clamp assembly. Engage the pin in the storage setting.
•
Rotate the table
opposite from use
until the table has turned 180 degrees
and rests against the cross bar on the A-frame.
•
The legs of the A-frame base may then be folded together for compact
storage. (See Figure 11).
WARNING: This operation may pinch
fingers if not done slowly and carefully.
TABLE MAT: REMOVING / CLEANING / TIGHTENING
•
You may find it easier to remove the nylon mat while the table is in its
storage position.
•
Pull up on the plastic tension clips to loosen the adjustment straps.
•
Release one corner at a time, then slide the mat off the frame.
•
The mat should be washed in cold on gentle cycle. Replace the mat on
the table frame while still wet.
•
If you feel the nylon mat needs to be tightened, pull the adjustment straps
on the back of the mat.
POST ASSEMBLY ADJUSTMENTS
MAINTENANCE
STORAGE
CHANGING THE ROLLER HINGE SETTING
•
Stand with your legs on either side of the main shaft.
•
Reach under each roller hinge with your index fingers. Use your thumbs to release the
locks over the roller hinges.
(See Figure9)
•
Lift both sides of the Table Frame out of the A-frame at the same time. You may rest
the table on the crossbar of the A-frame.
•
Unlock the cam locks for each roller hinge. Change the roller hinges to the desired
setting (A, B, or C, from most aggressive to least aggressive).
(See Figure 10
)
•
Relock the cam locks. Replace the roller hinges into the hinge plates of the A-frame.
Figure 9
A
B
C
Shows pin in
Setting C
Figure 10
