STEP SIX
Insert the Main Shaft (GL9521) into the Table Frame (F81021)
•
Loosen the de-rattler knob on the main shaft housing.
•
With the height adjustment settings on the main shaft facing up, slide the
end of the main shaft into the blue bushing in the main shaft housing.
(See
Figure 6)
•
Pull out the height selector locking pin to allow the main shaft to slide in
further. For the purpose of easy assembly, slide the main shaft in all the
way and release the pin in the storage setting. (Refer to the Owner’s
Manual for proper height adjustment before use).
•
Tighten the de-rattler knob.
STEP EIGHT
Testing the Assembly
PRIOR TO USE:
•
Test the table by hand for smooth and steady rotation.
•
Ensure all fasteners are secure.
You have completed the assembly of your Teeter Hang Ups
®
Inversion
Table.
•
Read your Owner’s Manual thoroughly before using the inversion table. Im-
proper settings could result in serious injury or death.
•
For your reference, the table’s serial number can be found at the base of the
table frame on the back.
•
Please complete and mail your warranty card, or submit it on-line at
www.STLIntl.com.
de-rattler
knob
WARNING
!
Read the Owner’s Manual for information on
selecting the correct user height setting.
Improper settings could result in serious injury or death.
!
Assembly Instructions #LG9501 Pg. 3
Figure 7
STEP FIVE
Assemble Rear Bar with Ankle Clamps (F51052)
•
With the rounded corners of the rear foam ankle piece facing down, insert
the rear bar with one ankle clamp into the large hole at the bottom of the
main shaft (GL9521).
(See Figure 5)
•
Align the hole in the rear bar with the hole on the main shaft and insert
the Hex bolt (F51087) into the holes from the rear. Install the washer and
nut; tighten with the wrenches provided.
•
Slip the other foam ankle clamp with silver backing (rounded corners
down) onto the rear bar and push the black rubber plug (F51056) into the
bar. See
Figure 5A
for correct assembly.
ASSEMBLY
Figure 5A
Figure 5
Figure 6
STEP SEVEN
Attach the EZ-Angle Tether Strap (F51008) to Limit the Degree of Rotation
•
Attach the clip to the desired strap angle and hook the clip to the loop at the
base of the table bed.
• 20° - Secure the clip to the green strap for inversion to a gentle 20°.
• 40° - Secure the clip to the blue strap for inversion to a moderate 40°.
• 60° - Secure the clip to the black tip of the strap for inversion to a more
advanced 60°. This is the angle when all the benefits of inversion
are realized.
• 90° - Remove the tether strap entirely for full inversion and exercise!
Hook tether
strap here.
60
°°°°°
40
°°°°°
blue
20
°°°°°
green
No Strap:
90
°°°°°
