Assembly Instructions #LG9501 Pg. 2
Refer to the Owner’s Manual for an explanation of the hole settings.
We suggest using Setting C to start.
ASSEMBLY
STEP THREE
Install Roller Hinges (F51064) to Table Frame (F81021)
•
For ease of assembly, rest the table frame against the crossbar at the
front of the A-frame.
•
Open the cam locks on each side of the table frame.
•
With the grooved pivot pins facing out, insert the roller hinges into the
brackets on each side of the table frame.
(See Figure 3)
The roller hinges
will slide between the cam locks and the brackets.
(See Figure 3A)
•
Make sure that the roller hinges are in the same hole setting on both
sides.
•
Push down on the cam lock to secure the hinge.
Figure 3B
shows the
roller hinge engaged correctly (in Setting C).
STEP FOUR
Attach the Table Frame (F81021) to the A-frame Base (GL9520)
•
Holding each side near the roller hinges, pick up the table frame and stand at
the front of the A-frame. Lower each pivot pin into the A-frame hinge plates at
the same time.
(See Figure 4)
Figure 4A
shows the correct placement of the
pivot pin into the hinge plate.
•
Make sure that both pivot pins are seated at the base of the slot in the
hinge plate.
•
Check to make sure that the self-locking hooks have closed over both
pivot pins and that the table rotates smoothly.
Figure 4
Figure 4A
Figure 3B
Figure 3A
Hinge
into
bracket
Close
cam lock
In Setting C
pivot
pin
Failure of the self-locking hooks to close over both pivot pins
is indication of improper assembly and if not corrected,
could result in serious injury or death.
WARNING
!
Figure 3
STEP TWO
Install Handles (GL9518, GL9522) and Shrouds (GL9524) on A-frame
Base (GL9520)
•
Insert two double threaded bolts (GL9523) through the base of the Left
Handle (marked with an “L”) and hand tighten on the outside with the
nuts provided. (See Figure 2) Line up and insert the opposite end of the
bolts through the corresponding 1/3” holes on the outside of the hinge
plate. Loosely tighten with nuts, then use the wrenches provided to
tighten both sets of nuts, being careful not to over tighten. Repeat with
the Right Handle.
•
Place one of each shroud over the outside edge of the corresponding
handle. Line up and insert shroud bolts (GL9525) through the smaller
1/4” holes in the hinge plate (See Figure 2). Use the wrenches
provided to tighten the nuts, being careful not to over tighten.
Figure 2A
NOTE: Nuts and bolts
may be packaged
separately or
assembled in
handles and shrouds.
Figure 2
( L )
