5
HandyTrac Touch
User Guide
Mount the Control Box
Insert the Key Panels
1.
Hold the control box flush against the side
of the cabinet. The Electronic Lock port
on the side of the cabinet must be aligned
with the electronic lock cables from the
control box.
2. Before mounting the control box, gently
feed the electronic lock cables through
the electronic lock cable port on the right
side of the key cabinet.
Fasten the control box to the wall.
3. Connect the electronic lock, light, and
switch connectors inside the key cabinet.
The ends of each connector are labeled.
4. Snap the cables into the retaining clips
on the inside of the cabinet to prevent
contact with the key panels during
operation and to protect the cables.
1. Each panel is labeled with a letter in the upper
outside corner, and each hook has a number.
2. The panels should be placed in alphabetical order
from front to back in the cabinet (AB/CD/EF/GH).
3. Insert the top panel mounting pin into a hole on
the top key panel mounting bracket. Raise the
panel up and rotate the bottom mounting pin into
the corresponding hole at the bottom bracket.
4. Repeat for all panels.
Note: Pay close attention to the
labels on the wiring. Make sure
LOCK
is connected to
LOCK
and
LIGHT
to
LIGHT
.