H&S BW1000 LINEWRAP BW1000 LINEWRAP, Руководство оператора

Страница: 33 / 38

-31-
TENSIONERS
If wrinkles appear in plastic while wrapping. . .
1. Check to make sure the wrap is threaded properly.
If plastic tears between tensioner and bale. . .
1. Make sure film holders are free. Turn holders by hand until free.
2. Use a higher quality plastic. Some brands are more tear resistant than others.
3. If the film on the roll is damaged, unroll the film until the damaged area has been removed.
4. Tensioners may be tacky. If tensioners are built up with adhesive from wrapping in hot weather,
clean with mineral spirits.
ENGINE DOESN’T START
1. Engine out of gas.
2. Gas shut-off is closed
3. Not getting gas, set choke to full
For other starting problems, refer to engine manufacturers owners manual.
MACHINE DOESN’T WRAP IN REMOTE, MANUAL, OR AUTOMATIC MODES
1. Press the start/reset button.
2. Insure wiring harness is properly connected to control box.
3. Insure wiring harness is properly connected to the engine.
MACHINE DOESN’T WRAP IN THE AUTOMATIC MODE
1. Press the start/reset button.
2. Make sure pusher is in the home position. The machine will not begin a wrapping cycle unless the
pusher is in the home position (i.e., the limit switch that stops the pusher at the end of the cycle must be
activated). If not in the home position, put machine in manual mode and manually return the pusher to the
home position.
MACHINE DOESN’T WRAP IN THE MANUAL MODE
1. Press the start/reset button.
2. Make sure mode selection switch is in manual mode.
TROUBLESHOOTING